Technical Data - Hitachi CP2896TA Wartungshandbuch

32
Before you call a serviceman
Problem
After a power failure, thunderstorm, etc. a malfunction
may occur. Example: The receiver does not respond to
the remote control commands.
Regular vertical or diagonal lines are shown on the
screen.
The colour purity of the picture tube is poor.
Permanent distortion on the screen (on its edges).
When selecting a programme number (not E
programme number), either a programme from a device
connected to the Scart E1 connection is shown, or there
is no picture at all on the screen.
Some programme channels or menus cannot be
selected, or the message "Enter code number to open
lock" appears on the screen.

Technical data

System
Mains power
Power consumption
Power consumption in stand-by
Picture tube
Frequency range
Programme memory locations
AV memory locations
Sound output
Connections on the front panel
Headphones
Audio/Video
Connections on the rear panel
Audio/Video (Scart)
Audio out
Ext. loudspeakers
Antenna
Specifications are subject to change.
Solution
Switch off the receiver by using the mains switch, wait
for about 10 seconds and switch the receiver on again.
Connect a double shielded aerial cable between the
aerial connector of the receiver and the aerial wall
socket.
Switch off the TV set by using the mains switch and
allow it cool down for about 15 minutes. When the TV
set is switched on again, automatic degaussing of the
picture tube maintains the colour purity.
Move all devices causing strong magnetic fields, e.g.
additional loudspeakers farther away from the TV set.
Switch off the TV set by using the mains switch and
allow it cool down for about 15 minutes. When the TV
set is switched on again, automatic degaussing of the
picture tube maintains the picture format and colour
purity.
Check that the Decoder setting in the Manual tuning
menu is set to OFF.
See instructions in the section "Parental lock". If you
have lost the code number, use the sequence 1-5-9-red
"ZOOM" button on the remote control unit to open the
lock.
PAL B, G
NTSC 3.58/4.43 via Scart connector
210-240 V, 50 Hz
135 W (normal)
max. 0,2 W
28"/71 cm, 29"/74 cm
48.25 - 855.25 MHz
99
3
/8 Ω
2 x 10 W
RMS
32...600 Ω, 3,5 mm
Audio in: 0 - 2 V /1 kΩ
RMS
Video in: 1 V/75 Ω
Y/C in (SVHS)
Audio in: 0 - 2 V /1 kΩ
RMS
Audio out: 0 - 2 V /10 kΩ
RMS
Video in/out: 1 V/75 Ω
RGB in: 0,7 V/75 Ω (E1)
Y/C in (SVHS) (E2)
0 - 2 V /10 kΩ (RCA)
RMS
/8 Ω
min. 10 W
RMS
75 Ω, coaxial cable
3P58 83041010-GB