Description Of The Appliance; Preparing The Appliance - Kärcher SCP 6000 Betriebsanleitung

Do not scrape the power cord across
sharp edges and ensure that it does not
get pressed.
The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
To avoid risks, all repairs and replace-
ment of spare parts may only be carried
out by the authorised customer service
personnel.
Follow the rules for electrical safety of
equipment:
Immersion pumps should be operated
in swimming pools, garden ponds and
fountains only using a earth-leakage cir-
cuit breaker with a nominal leakage cur-
rent of max. 30 mA. Do not operate the
pump if there are persons located in the
swimming pool or the garden pond.
For safety reasons, we recommend that
you operate the appliance only via a
earth-leakage circuit breaker (max. 30
mA).
The electrical connection of the system
may only be performed by a qualified
electrician. Please follow the respective
national regulations!
In Austria pumps to be used in swim-
ming pools and garden ponds should be
equipped with a fixed connection line
according to ÖVE B/EN 60555 Part 1 to
3; power supply should be via a ÖVE-
tested isolating transformer whereby
the secondary nominal voltage should
not exceed 230V.
This device is not intended for use by
persons (including children) with re-
duced physical, sensory or mental abili-
ties or lacking experience and/or
knowledge, unless they are supervised
by a person responsible for their safety
or are instructed by these persons on
the use of the device. Children should
be supervised, in order to guarantee
that they do not play with the device.
Start up

Description of the Appliance

1 Power cord with plug
2 Level sensor
3 Level sensor stopper
4 Carrying handle
5 Hose connection 1" (25.4 mm)

Preparing the Appliance

Illustration
Screw the hose connection on to the
pump
Note
The shorter the hose, the higher the feed
rate.
Push the hose on the hose connection
and fasten it with appropriate hose clip
Illustration
In automatic operations mode, set the
required switching height by clamping
the level sensor cable in the stopper.
Illustration
In manual operations mode, align the
level sensor upward (cable pointing
downward). Tip: Push the cable of the
level sensor like a loop through the han-
dle.
Illustration
Place the pump on a level, stabile sur-
face in the liquid to be transported, en-
sure that it is standing firmly or immerse
it using a rope tied to the handle.
The suction area should not be blocked
fully or partially through the impurities.
13
English