Positioning The Appliance; Installation Versions - STIEBEL ELTRON STH 210 Plus Bedienung Und Installation

INSTALLATION
Installation
8.3 Transportation to the installation site
Material losses
!
We recommend removing the cylinder casing for trans-
portation to the installation site to prevent it from be-
coming dirty or damaged (see chapter "Removing the
cylinder casing").
8.3.1 Removing the cylinder casing
1 Cover
2 Cylinder casing
3 Plinth trim
f First remove the cover and then the plinth trim. f
f Remove the cylinder casing. f
STH 720 Plus | STH 720-1 Plus
In the case of narrow transport routes, you can remove the side
insulation segments. To do this, remove the cylinder casing.
f Use the retaining straps to refit the insulation segments after f
transportation.
16 | STH Plus
1
2
f Ensure that the closures are positioned in the joint between f
3
a side insulation segment and the thermal insulation of the
cylinder.
8.4

Positioning the appliance

STH 210-415 Plus
This appliance comes with adjustable feet as standard.
f The adjustable feet can be extended outwards to compensate f
for any unevenness in the floor.
STH 720 Plus
This appliance does not have adjustable feet. The floor must be
level.
8.5

Installation versions

Installing the threaded immersion heater
The threaded immersion heater is used for electric booster heat-
ing.
- With the STH 210-415 Plus, one threaded immersion heater
can be installed on the r.h. or l.h. side.
- With the STH 720 Plus | STH 720-1 Plus, one or two threaded
immersion heaters can be installed.
f Remove the cap from the connection. f
f Undo the plug with a size 32 socket spanner. f
www.stiebel-eltron.com