Error Rectification - BWT bestaqua 14ROC Coffee Einbau- Und Bedienungsanleitung

22

6.2 Error rectification

App screen
BWT
14ROC COFFEE
leakage
BWT
14ROC COFFEE
pump
cooling
BWT
14ROC COFFEE
no
water
BWT
14ROC COFFEE
009 18
uS C°
CONDUCTIVITY H 0 TEMP
2
7.8 186
bar
OUTLET PRESS DAYS
fault 0001
liter hours
INLET WATER PUMP ON
09852 090
liter liter/hour
OUTLET WATER OUTLET FLOW
info back
Flashing LEDs Error
Water leak in-
side the device
Inlet valve clos-
es automati-
cally.
Status LED turns
red and a warn-
ing signal sounds
Pump motor no
longer working
Status LED flashes
red once evenly
Pump motor no
longer working
The status LED
repeatedly flash-
es twice
The app shows
"fault" for inlet
water.
The device re-
mains in oper-
ation.
The status LED
repeatedly flash-
es three times
Cause Remedy
Leak or condensa- Disconnect device
tion inside the de- from electricity and
vice water supply
Check pump and
pipes, dry leak sensor
Motor overheat- The device will re-
ing protection trig- start automatically
gered when the motor has
cooled down.
If this error appears
after initial installation
and does not disap-
pear, please check
the electricity supply
to the booster pump.
No or insufficient Check pre-filter for
raw water input blockage and replace
if necessary
Check check valves,
open if necessary,
and check flow pres-
sure
4 bar)
Inlet water pres- Install pressure boost-
sure too low er if necessary
The inlet water Permeate is still pro-
meter is blocked duced but the inlet
or has no power water volume is not
supply. recorded.
Check power supply.
Replace inlet water
kit if necessary!
(RO working range: 1 to