Tips And Hints; Expanding The Multi-Train System; Massoth Dimax Navigator - LGB MZS Zentrale III Bedienungsanleitung

All manuals and user guides at all-guides.com

Tips and hints

- The LGB Multi-Train System sup-
plies a constant voltage to the
tracks. Lights and smoke genera-
tors in locomotives and cars can
operate at all times, even when they
are standing. You can connect
other accessories, such as signal
lights and switch lanterns, directly
to the tracks.
- The power consumed by acces-
sories reduces the power available
to your trains.
- Some electronic
including some older 5 volt car
lighting circuits, adversely affect
the operation of the Multi-Train
System.
- Locos equipped with decoders can
be used on conventional analog
layouts without modification.
Expanding the LGB Multi-Train
System
The LGB Multi-Train System offers
numerous possibilities for expanding
your layout, all the way to fully auto-
mated control of your entire layout
from your PC. For more information,
visit your authorize LGB retailer.
Operation with Massoth DiMax
Navigator
The LGB 55006 MTS Central Station
III can be used with the Massoth
DiMax Navigator (MTS III). The
DiMax Navigator offers numerous
advanced functions. If your loco
decoder is programmed to 28 speed
steps, the DiMax Navigator allows
sensitive loco control with 28 speed
steps.
The DiMax Navigator allows pro-
gramming loco addresses 1 - 10239
(for decoders that allow this address
range). When using the LGB 55016
Loco Remote, the DiMax Navigator
enables programming of loco address-
es 1 - 15.
For more information, check the
instructions for the Massoth DiMax
Navigator or online at www.mas-
soth.com
Troubleshooting
Locomotives do not work reliably.
Is the track dirty? Dirty track can pre-
vent commands and power from
reaching the locos. Clean dirty tracks
with a 20670 Track Cleaning
Locomotive (with decoder), 50050
Track Cleaning Attachment or 50010
components, Smoke and Cleaning Fluid.
- The LEDs on the Central Station
are off.
- The system is not receiving power.
- Is the power supply plugged in?
- Is the power supply properly con-
- If you use a DC power supply: Is
- Is the transformer overloaded?
Press the Reset button on the
transformer (if applicable).
- The Central Station LED is green,
but the system does not work.
- The LED on your MTS throttle is
flashing.
- Is there a short circuit? Remove
nected to the Central Station?
the polarity of the power supply
correct? (To reverse the polarity,
reverse the power pack's direction
or swap the wires to the Central
Station.)
- Is the Central Station properly
connected to the track?
- Are the MTS throttles properly
connected to the Central Station?
- Has the Emergency Stop button
been pressed? To restart after an
emergency stop, do not press the
button repeatedly. Wait for the
LED on the MTS throttle to flash
three times. Now press the
Emergency Stop button once.
the cause of the short circuit, then
press the Emergency Stop button
to resume operations.
15