Direction And Speed; Emergency Stop; Locomotive Light(S); Auxiliary Functions - LGB Lokhandy 55016 Handbuch

Direction and Speed

The Locomotive Handheld Locomotive Controller has
two different types of control. Zero setting in the middle
and zero setting on the left. You can switch between
these types of control during operation.
Zero Setting in the Middle
Set the switch on the lower end of the hand controller
to the right. When the control knob is turned to the right,
the locomotive runs forward. When it is turned to the
left, the locomotive runs in reverse.
Zero Setting on the Left
Set the switch on the lower end of the Handheld
Locomotive Controller to the left. Now you have the full
range of movement from your control knob available for
a direction of travel. Turn the control knob to zero and
turn it against the spring-loaded stop in order to change
the direction.
12

Emergency Stop

You can activate an emergency stop or a pause with the
button with your Handheld Locomotive Controller.
STOP
The rails then immediately have no current in them. This
is indicated by the blinking of the upper monitor light
on the Handheld Locomotive Controller (not with radio
remote control).
Pressing on the button again cancels this inter-
STOP
ruption.
The locomotives will run again as they did before the
emergency stop.
When you do a reset at the central unit, the running data
set in the Locomotive Hand Controller is lost.

Locomotive Light(s)

You can turn the light(s) on your locomotive on and
off using the button. Your locomotive must have
9
been converted to digital and the light must have been
installed on the correct output on the decoder.

Auxiliary Functions

You can call up the auxiliary functions on your locomo-
tive using the to
1 8
have been converted to digital and it must have auxiliary
functions.
buttons. Your locomotive must