Transplant Distance - Checchi & Magli F 300 L Bedienungsanleitung

F 300 L
Adjust to the required speed by means of the gear change, keeping at the lowest
possible rpm.
Make certain that the tractor's exhaust fumes are not directed at the operators and
that the silencer is completely efficient. By adhering to the above instructions, it is
possible to work with limited noise levels, thus facilitating communication between
the operators and the tractor driver.
-AVOID REVERSE MOTIONS WITH THE TRANSPLANTER STILL ON THE SOIL.

18.0 - TRANSPLANT DISTANCE

18.1 -INTER-ROW SPACING
The distance between rows is adjustable by moving the units (Fig. 12.A) with respect
to the frame (Fig. 12B).
Minimum 55 cm Maximum 90 cm (or more, upon request).
18.2 - INTER-PLANT SPACING
Diagram (fig. 13.A) shows the distances which can be obtained with the standard
gear ratios.
Diagram (Fig. 13.B) shows the distances which can be obtained with the optional
gear ratios. To change the standard gears (Fig. 14.A) and obtain the distances
indicated, observe the safety regulations (ref. 8.0), and proceed as follows:
-Remove the casing (fig. 12.C)
D
-Release the chain tensioner
(Fig. 14.B)
-Remove the chain (Fig. 14.C)
-Change the gears (Fig. 14.D
C
and E) by turning the appropriate
fixing screws, positioning them
as shown in the table (fig. 13),
depending on the distance
required.
-Reposition the chain
-Tighten the chain using the
tensioning device.
-Fix the casing in place (Fig.
B
A
12.C).
E
FIG. 14
B
A
B
A C
FIG. 12 FIG. 13
35