Operation; Cleaning And Maintenance; Cleaning; Maintenance - ULTIMATE SPEED 12 V UOP 12 C1 Originalbetriebsanleitung

˜ Operation
1 . Start the vehicle and run it for 5-10 minutes
to warm up the oil (60 °C is the maximum oil
temperature) . This reduces viscosity of the oil
and enables to pump it out more efficiently .
m
Do not pump the oil when the car
engine is running.
2 . Gently insert the suction hose (Ø 6 mm) 9
into the bottom of the oil pan (e .g . by the oil
level test opening) .
3 . Insert the drain hose (Ø 12 mm) 11 into a
container (e .g . oil collecting tray) .
4 . Set the on/off switch 1 to "O" (off) position .
5 . Connect the positive pole clamp (red) 4 to
the positive pole (+) of the vehicle battery .
6 . Connect the negative pole clamp (black) 5 to
the negative pole (‒) of the vehicle battery .
7 . Turning on: Set the on/off switch 1 to "I"
position . The pumping begins after a short
suction period .
8 . Turning off: Set the on/off switch 1 to "O" .
Turn the appliance off as soon as oil extraction
is over or after 30 minutes of continuous

operation .

9 . After each use, pump through some fresh oil to
clean the appliance .
10 . Remove the negative pole clamp (black) 5
from the negative pole (‒) of the vehicle
battery .
11 . Remove the positive pole clamp (red) 4 from
the positive pole (+) of the vehicle battery .
m
To prevent damage, let the appliance
cool for at least 10 minutes after
every 30 minutes of continuous
operation.
12 . Change the oil filter and refill with new oil
according to the vehicle instructions .
13 . Used oil needs to be disposed of in a way
according to "Disposal" .
˜ Cleaning and maintenance
m
WARNING! During cleaning or operation,
do not immerse the electrical parts of the
appliance in water or other liquids . Never hold
the appliance under running water .

Cleaning

1 . After each use, pump through some fresh oil to
clean the appliance .
2 . Clean both clamps 4 , 5 with a dry cloth
after each use . Make sure there is no adhering
battery fluid left on the appliance .
3 . Keep the casing 2 and accessories clean .
Do not use abrasive, aggressive or chemical
cleaning agents to clean the surface of the
appliance .
4 . In case of oil spillage, clean it with a soft cloth
or a paper towel .

Maintenance

Check the hose clamps 10 for tight fit .
Before each use check the appliance and all its
accessories for any visible damage .
Apart from the occasional cleaning, the
appliance is maintenance-free .

Storage

When not in use, store the cleaned appliance
in a dry, secure location away from children .
Store used oil / diesel in appropriate
containers only .
GB/IE 23