Handling And Operation; Infl Ation Operation; Air Pump Operation - ULTIMATE SPEED KH 4256 Originalbetriebsanleitung

Handling and operation

In this chapter you receive important information for the handling and operation of the
appliance.
Ensure that the appliance is switched off (the function switch
connect the cable to the cigarette lighter.
GB
MT
Infl ation operation

Air pump operation

50
IMPORTANT
► This appliance is not suitable for continuous operation. Continuous usage
for more than 30 minutes in infl ation operations (10 minutes for air pump
operations) can cause overheating and damage to the appliance. Switch
the appliance off after the specifi ed time and take it back into operation
again ONLY when the motor has cooled down.
♦ Remove the valve cap of the article to be infl ated.
♦ Fit the appropriate valve adapter attachment
of the appliance.
♦ Insert the valve adapter bonnet
♦ Switch the appliance on, in that the function switch
tion "II".
♦ When the desired infl ation level has been reached, switch the appliance off
(function switch
2
attachment 6 from the infl ated article.
♦ Replace the valve cap back onto the infl ated article.
♦ Check to see if a valve adaptor attachment
object to be infl ated.
Should this be the case: Press the appropriate adapter valve bonnet
into the opening of the connection valve
down.
♦ If you do not have to use an adapter valve bonnet
closure of the connecting valve
must point to the rear.
♦ Place the opened connection valve
pressure is to be measured and then press it down so that it is seated fi rmly.
♦ Close the connection valve
Ensure that the connection valve cannot loosen itself.
♦ Switch the appliance on, in that the function switch
position "I".
Handling and operation
6
into the valve of the article to be infl ated.
to the position "0") and then remove the valve adapter
5
is open. When open, the closing lever
5
on the valve of the object whose air
5
in that you push the closing lever down.
5
is at position "0") and then
2
6 on the air outlet opening
is placed in the posi-
2
7 is required for use on the
and then push the closing lever
7 , ensure that the
is placed in the
2
7
KH 4256