Use; Warnings - Olimpia splendid Unico R32 EDGE Hinweise Für Die Verwendung Und Pflege

After performing the mechanical operations for changing the air outlet
flap, it is necessary to configure the control electronics of the machine
(see fig.40):
a. Connect the power supply line.
b. Make sure the machine is in stand-by, LED A on.
c. Keep the reset button H pressed until an acoustic signal
sounds.
d. HIGH WALL CONFIGURATION: press and hold button
H again until LED C (yellow) lights up.
FLOOR CONFIGURATION: press and hold button H
again until LED B (green) lights up.
e. Release the display button H and wait a few seconds
until the stand-by configuration is restored, LED A on.

3 - USE

3.1 - WARNINGS

The installation and electrical connection of the air conditioner should be carried out by specialized
personnel who possess the requisites set forth by law.
The installation instructions are contained in the appropriate paragraph of this manual.
No structural object (furniture, curtains, plants, leaves, blinds, etc.) should ever
obstruct the normal flow of air from either the internal or external gratings.
• Never lean or, worse yet, sit on the casing of the air conditioner as this could cause serious
damage to the external parts.
• Do not move the air outlet flap by hand. Always use the remote control to adjust baffle position.
• If the unit leaks water, switch it off immediately and disconnect it from the power mains. Call
the nearest service centre.
• When the air conditioner is heating, it has to periodically eliminate any ice that could form on
the external battery. While it is doing this, the machine keeps running but does not heat the
room. This lasts for a brief period of time, from 3 to a maximum of 10 minutes.
• Clean the air filter periodically, as described in the specific paragraph (4.1.2).
The air conditioner must not be installed in rooms where explosive gasses de-
velop or where there are conditions of heat and humidity beyond the maximum
limits indicated in the installation manual.
G LED D LED B
LED C LED A
UNICO EDGE R32
H
40
EN - 21