Technical Data; Noise/Vibration Information - Würth EWS 7-115 BASIC Originalbetriebsanleitung

(14) Handle (insulated gripping surface)
(15) Grinding spindle
A)
(16) Hand guard
A)
(17) Rubber sanding pad
A)
(18) Abrasive disc
A)
(19) Round nut
Angle grinder
Article number
Rated power input
Rated speed
Max. grinding disc diameter
Grinding spindle thread
Max. thread length of grinding
spindle
Restart protection
Speed preselection
Weight according to EPTA-Procedure 01:2014
– with additional low-vibration auxili-
ary handle
– with standard auxiliary handle
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.

Noise/Vibration Information

Noise emission values determined according to
EN 60745-2-3.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 91 dB(A); sound power level
102 dB(A). Uncertainty K = 3 dB.
Wear hearing protection
Total vibration values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-3:
Surface grinding (roughing):
2 2
a =6.5 m/s , K=1.5 m/s ,
h
Grinding with abrasive disc:
2 2
a =3.5 m/s , K=1.5 m/s .
h
The vibration level given in these instructions has been meas-
ured in accordance with a standardised measuring procedure
and may be used to compare power tools. It can also be used
for a preliminary estimation of exposure to vibration.
The stated vibration level applies to the main applications of
the power tool. However, if the power tool is used for different
applications, with different application tools or poorly main-
tained, the vibration level may differ. This can significantly in-
crease the exposure to vibration over the total working period.
(20) Cup brush
(21) Extraction guard for cutting with a cutting guide
(22) Diamond cutting disc
A) Accessories shown or described are not included with
the product as standard. You can find the complete
selection of accessories in our accessories range.

Technical Data

EWS 7-115 BASIC
5707 011 X
W 720
rpm 11,000
mm 115
M 14
mm 22
●
–
kg 1.9
kg 1.8
/ II
To estimate the exposure to vibration accurately, the times
when the tool is switched off or when it is running but not actu-
ally being used should also be taken into account. This can
significantly reduce the exposure to vibration over the total
working period.
Implement additional safety measures to protect the operator
from the effects of vibration, such as servicing the power tool
and application tools, keeping the hands warm, and organ-
ising workflows correctly.
Fitting protective equipment
Pull the plug out of the socket before carrying
r
out any work on the power tool.
Note: If the grinding disc breaks during operation or the
holding fixtures on the protective guard/power tool become
damaged, the power tool must be sent to the after-sales ser-
vice immediately; see the "After-sales service and advice on us-
ing products" section for addresses.
A)
A)
EWS 7-125 BASIC EWS 7-125 E BASIC
5707 012 X
720
11,000
125
M 14
22
●
–
1.9
1.8
/ II
Fitting
A)
5707 013 X
720
2800–11000
125
M 14
22
●
●
1.9
1.8
/ II
21