Intended Use; Noise/Vibration Information; Technical Data - Würth EBS 125-E Originalbetriebsanleitung

Intended use

The machine is intended for the grinding and
removal of concrete, screed and coatings using
diamond cup wheels. Only use without water.
If used on thermoelastic materials, the brush ring can
become stuck down.
Intended for commercial use in industrial or work-
shop environments.
The machine must not be used for abrasive cutting,
rough grinding, sanding, polishing or work with flap
discs.
Only work with a suitable dust collection system:
Connect a vacuum cleaner (class M) to suction noz-
zle [12] . Use only original Würth accessories. Any
other use or use beyond this scope is considered
improper use.
The user is solely responsible for damage
resulting from improper use.

Technical data

Parameter
Rated power consumption
Power output
Grinding wheel dia., max.
Spindle thread
Idle speed
Max. permissible thickness
of the attachment in the
clamping area when using a
clamping nut
Weight without mains lead
Symbols on the name plate:
n = max. no-load speed
∼ = Alternating current
5707 701 X
1700 W
950 W
125 mm
M 14/20
2,200 - 8,500 rpm
10 mm
3.2 kg

Noise/vibration information

The noise level may exceed 80 dB (A)
during work.
Risk of severe injuries and acoustic
Â
trauma.
Wear hearing protection.
¾
Emission values
These values enable the estimating of the noise
emissions of the power tool and comparison with
various power tools. Dependent on the conditions
of use, state of the power tool or attachments, the
actual loading may be greater or smaller. When
estimating also take into consideration work breaks
and phases with lower loading. Specify protective or
organisational measures for the user based on the
corresponding adjusted estimation values.
a /K
m/s
2
h,S h,S
L /K
dB(A)
pA pA
L /K
dB(A)
WA WA
Vibration total value (vector sum in three directions)
measured in accordance with EN 60745:
a = Vibration emission value (surface grinding)
h, S
K = Uncertainty (vibration)
h, SG/DS
Typical A-rated sound pressure level:
L = Sound pressure level
pA
L = Sound power level
WA
* The specified vibration emission values:
• Were measured using a standardised test method
and can be used to compare one electric tool
with another.
• Can be used for a rough assessment of the
exposure.
WARNING !
5.61 / 1.5
93,9 / 3
104,9 / 3
17