Elica NT-FLAME-GR-DO Montage- Und Gebrauchsanweisungen Seite 66

EN - Instruction on mounting and use
Strictly observe the instructions in this manual. All liability
is declined for any problems, damage or fires caused by
failure to comply with the instructions in this manual. The
device is intended for domestic use only, to cook food
and extract the fumes generated by cooking. No other
use is allowed (e.g. heating rooms). The manufacturer
declines any liability for inappropriate use or incorrect
control settings.The device may have different
aesthetic features with respect to the illustrations in
this handbook, however the operating, maintenance
and installation instructions remain the same.
Read the instructions carefully: they include important
information about installation, use and safety.
Do not make electrical changes to the device.
Before installing the device, make sure that none of the
components are damaged. Otherwise, contact the dealer
and do not continue with the installation.
Check that the device is intact before continuing with
installation. Otherwise, contact the dealer and do not
continue with the installation.
Note: The parts marked with the symbol "(*)" are optional
accessories supplied only with some models or otherwise not
supplied, but available for purchase.
1. Warnings
Warning! Strictly observe the following
instructions: Before installation, make
●
sure that the local distribution conditions
(the gas type and pressure) and
equipment adjustment are compatible.
The device must be installed and
connected in compliance with current
installation regulations in the country of
destination/use. Special precautions
must be taken with respect to ventilation
requirements of the premises in which
the device to be installed.
is a class 3 recessed device.
instructions are only valid for countries
whose symbols are indicated on the
serial number plate.
intended for non-professional use in the
home. Do not allow the power cable for
●
the device in question and for other
This device
●
The
●
The device is
●
electrical appliances to come into contact
with the hot surfaces.
the openings for ventilation and heat
dispersion.
never access the internal mechanisms to
try to repair them. Contact technical
support.
●
pans are always facing towards the
inside of the hob to avoid accidentally
knocking them.
deformed pans.
disconnected from the electrical supply
before performing any installation work.
If the power cable is damaged, it must be
replaced by the manufacturer or by the
authorised technical support service or
by a technician with a similar qualification
to avoid any risks.
maintenance must be performed by a
qualified technician, in compliance with
the manufacturer's instructions and local
safety regulations. Do not repair or
replace any part of the device unless
●
specifically stated in the operating
manual.
●
compulsory.
to comply with current safety regulations,
a compliant omnipolar switch is required
that guarantees the complete
disconnection of the mains in category III
overvoltage conditions, in accordance
with the installation rules.
power strips or extension cords.
installation is complete, the electrical
components must no longer be
accessible by the user.
its accessible parts get hot during use.
65
Do not obstruct
●
In the event of a fault,
●
Make sure that the handles of
Do not use unstable or
●
The device must be
●
Installation or
●
Earthing the device is
In order for the installation
●
●
The device and
●
●
Do not use
Once
●