Setting The Desired Output Quantity; Automatic Power Off - Klarstein Futura Bedienungsanleitung

EN
24

SETTING THE DESIRED OUTPUT QUANTITY

Set output quantity for individual cups
Press and hold the SINGLE CUP button for 3 seconds to enter the dispensing amount
setting mode. Then press the SINGLE CUP button again. The coffee will start dispensing
and the SINGLE CUP indicator will flash. When the desired dispensing quantity is
reached, press the SINGLE CUP button again and the machine stops dispensing. At
this point, the single cup output quantity setting is finished and will be saved for the next
operation. The adjustable output quantity for single cups is between 25-60 ml.
Setting the output quantity of the double cup
Press and hold the DOUBLE CUP button for 3 seconds to enter the output quantity
setting mode. Then press the DOUBLE CUP button again. The coffee will start dispensing
and the DOUBLE CUP indicator will flash. When the desired serving quantity is reached,
press the DOUBLE CUP button again and the machine stops serving. At this point,
the setting for the output quantity of the single cup is finished and is saved for the next
operation. The adjustable output quantity for double cups is between 70 ml and 1 10 ml.
Restoring the factory setting
Press and hold the SINGLE CUP and DOUBLE CUP buttons simultaneously for
3 seconds to restore the factory preset dispensing quantity.

AUTOMATIC POWER OFF

• If there is no operation within 29 minutes after pressing the power button, the device
will switch off automatically.
• If there is no operation after pressing the power switch after pumping approx.
215 ml of water, the pump switches off automatically.
• After pressing the power button, the pump switches off automatically if it is not in
operation for 180 seconds during milk frothing.