Winding The Bobbin - ELNA eXplore 340 Gebrauchsanleitung

Winding the bobbin

Pull out the flywheel to disengage the clutch.
1
1
flywheel
Draw the thread from the spool. Guide the thread
2
around the bobbin winder thread guide.
2
Bobbin winder thread guide
Thread through the hole in the bobbin from the inside
3
to the outside.
Put the bobbin on the bobbin winder spindle with the
free end of the thread coming out at the top.
3
Bobbin winder spindle
Push the bobbin to the right.
4
NOTE:
Do not move the bobbin winder spindle while the
machine is running.
With the free end of the thread held in your hand,
5
depress the foot control. Stop the machine when the
bobbin has been wound a few layers, and cut the
thread close to the bobbin.
Depress the foot control again. When the bobbin is
6
fully wound, it will stop automatically.
Return the bobbin winder to its original position by
moving the spindle to the left, and cut the thread as
illustrated.
Push in the flywheel to engage the clutch.
7
26