Inhaltsverzeichnis
Werbung
4-Step Buttonhole (Model 320)
Machine setting
Stitch:
q
Stitch width:
4 – 5
w
Stitch length:
0.5 – 1
e
Thread tension: 1 – 5
r
t
Presser foot:
Sliding buttonhole J or
1
Set the pattern selector dial at "
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
Draw both of needle and bobbin thread to the left.
Move the slider toward you so that the top mark 2
on the slider meets the start mark 1.
Start mark
q
Top mark
w
Needle thread
e
Bobbin thread
r
NOTE:
The scale on the slider is engraved in centimeters.
2
Sew forward until you reach the front marking of your
buttonhole. Stop sewing at a left stitch.
3
Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing at a right stitch.
4
Raise the needle to its highest position.
Set the pattern selector dial at "
needle reach the back marking of the buttonhole.
5
Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing. Set the stitch length dial to "0" and
the pattern selector dial at straight sewing.
Sew a few locking stitches.
6
Raise the needle and presser foot. Remove the fabric
from the machine and cut the sewing thread. Insert a
pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
Pin
t
Seam ripper
y
Adjusting the buttonhole stitch density:
Set the stitch length dial between "
buttonhole stitch density.
60
Buttonhole foot B
(optional)
".
". Sew 5 stitches,
". Sew until the
". Sew 5 stitches,
" to adjust the
Werbung
Inhaltsverzeichnis
