Back Light; Display Contrast; Maintenance; Battery Replacement - Bresser 7003300 Bedienungsanleitung

7 . Press any key on the front side to save alert on /off status and back to normal mode, or it
will automatically back to normal mode after 30 seconds without pressing any key .
TO SILENCE THE ALERT ALARM
Press [ALARM / SNOOZE] key to silence the alert alarm or let the alarm automatically turn off after 2
minutes .
NOTE:
- Once the alert is triggered, the alarm will sound for 2 minutes and the related alert icon and readings will
flash.
- If the alert alarm is automatically off after 2 minutes, the alert icon and readings will still keep flash until
the weather reading is out of the alert range .
- The weather alert will sound again when the weather readings falls into the alert range again .

BACK LIGHT

The main unit back light can be adjust, using the [ HI / LO / AUTO ] sliding switch to select the appropriate
brightness:
- Slide to the [ HI ] position for the brighter back light .
- Slide to the [ LO ] position for the dimmer back light .
- Slide to the [ AUTO ] position for the auto adjust back light that according to environment light level .

DISPLAY CONTRAST

Press [ ] key in normal mode to adjust LCD contrast in order to fit table stand or wall mount angle.
/

MAINTENANCE

BATTERY REPLACEMENT

When low battery indicator "
in OUT or CH section, it indicates that the
outdoor 7-IN-1 sensor and/or current channel
sensor battery power is low respectively .
Please replace with new batteries .

WIRELESS 7-IN-1 SENSOR MAINTENANCE

REPLACE THE WIND CUP
1 . Remove rubber cap and Unscrew .
2 . Remove the wind cup for
replacement .
CLEANING THE UV SENSOR AND
CALIBRATION
• For precision UV measurement,
gentle clean the UV sensor cover
lens with damp micro-fiber cloth.
• Over time, the UV sensor will
naturally degrade . The UV sensor
can be calibrated with a utility grade
UV meter, please refer to Calibration
section in previous page for about
the UV sensor calibration .
REPLACE THE WIND VANE
Unscrew and remove the wind
vane for replacement .
" is displayed
56
CLEANING THE RAIN COLLECTOR
1 . Rotate the rain collector by turning it
30°anti-clockwise .
2 . Gently remove the rain collector .
3 . Clean and remove any debris or
insects .
4 . Install the collector when it is clean
and fully dried .
CLEANING THE HYGRO-THERMO
SENSOR
1 . Remove the 2 screws at the bottom
of the radiation shield .
2 . Gently pull out the bottom 4 shields .
3 . Carefully remove any dirt or insects
on the sensor and ventilation fan (do
not let the sensors inside get wet) .
4 . Clean the shield with water to remove
any dirt or insects .
5 . Install all the parts back when they
are clean and fully dried .