Unit Setting; Back Light - Bresser 4Cast PRO Bedienungsanleitung

4.4.3 UNIT SETTING

Use the [ UNIT ] key to change the unit of the readings on the console display.
Below is the operation step:
- Press and hold [ UNIT ] key for 2 seconds to enter the unit setting mode.
- Short press [ UNIT ] key to proceed to the next setting step.
- Press [ / FORECAST ] or [
for quick-adjust.
- Press and hold [ UNIT ] key for 2 seconds to exit the unit setting mode at any time.
Setting items table:
Step Mode
Temperature unit Press [
1s
2 Rain unit
3 Wind speed unit
4 Distance unit
5 Baro pressure
unit
6 Light intensity

4.4.4 BACK LIGHT

The main unit back light can be adjust, using the [ HI / LO / AUTO ] sliding switch to select the
appropriate brightness:
- Slide to the [ HI ] position for the brighter back light.
- Slide to the [ LO ] position for the dimmer back light.
- Slide to the [ AUTO ] position for the auto adjust back light that according to environment light level
/ INDEX ] key to change the value. Press and hold the key
/ INDEX ] or [
Press [ / INDEX ] or [
Press [ / INDEX ] or [
or mph
Press [ / INDEX ] or [
Press [ / INDEX ] or [
mmHg
Press [ / INDEX ] or [
Setting procedure
/ MODE ] key to select °C or °F
/ MODE ] key to select mm or in
/ MODE ] key to select m/s, km/h, knots
/ MODE ] key to select k/m or mi (miles)
/ MODE ] key to select hPa, inHg or
/ MODE ] key to select Klux, Kfc or W/m
70
2