Securing The Machine; Electrical Connection - Miele PDR 914 HP Kurzgebrauchsanweisung

Securing the machine

The tumble dryer must be secured to the floor by fitting the tensioning strips supplied

over the machine feet.
Fittings supplied are for bolting the machine to a concrete floor. For other types of floor-
ing, please purchase suitable fastening materials separately.
If the heat-pump unit is tilted up to a maximum of 30° during transportation, it must be left
to stand for at least one hour after it has been installed before the heat-pump dryer can be
operated.
If the heat-pump unit was tilted by an angle exceeding 30° or if it was subjected to strong
vibrations, the machine must be left to stand for 24 hours before commissioning.
After transportation and installation, downtime of at least one hour is required before
connecting the tumble dryer to the electricity supply.
Insufficient downtime before commissioning can damage the heat-pump.

Electrical connection

The electrical connection must be established by a qualified electrician.

The electrical connection may only be made to an electrical system provided in accord-
ance with all appropriate local and national legislation, regulations and guidelines. Please
also observe the regulations set out by your insurance provider and energy supplier, acci-
dent prevention regulations, as well as recognised codes of practice.

Reliable and safe operation of this tumble dryer is only ensured if it has been connected
to the mains electricity supply.
The required supply voltage, power rating and fuse rating can be found on the data plate
on the tumble dryer. Ensure that the supply voltage matches the voltage quoted on the
data plate before establishing the electrical connection to the tumble dryer.
Connection to a supply voltage other than the one quoted on the data plate can damage
the tumble dryer if the voltage is too high.

If more than one voltage is specified on the data plate, the tumble dryer can be conver-
ted for connection to the relevant input voltage. This conversion must be performed by the
Miele Customer Service Department or by an authorised dealer. During the conversion, the
wiring instructions given on the wiring diagram must be followed.
The tumble dryer can either be hard-wired or connected using a plug-and-socket connec-
tion in accordance with IEC 60309-1. For a hard-wired connection, an all-pole isolation
device must be available at the installation site.
en - Installation
155