Installation; Installation Requirements; General Operating Conditions; Transport - Miele PDR 914 HP Kurzgebrauchsanweisung

en - Installation

Installation requirements

The heat-pump dryer must only be installed and commissioned by a Miele Service en-
gineer or a Miele-authorised Service dealer.

The heat-pump dryer must be installed in accordance with all relevant regulations and
applicable standards.

This heat-pump dryer must only be operated in a room that has sufficient ventilation and
which is frost-free.

General operating conditions

This heat-pump dryer is intended only for use in a commercial environment and must only
be operated indoors.
Ambient temperature for optimum heat-pump operation:
+15 °C to +43 °C
The ambient temperature for the heat-pump dryer must be at least 10 °C.
At lower ambient temperatures, there is a risk of ice forming on the lower heat ex-
changer. This can also result in unexpected condensate formation.
Depending on the nature of the installation site, sound emissions and vibrations may oc-
cur.
Tip: Have the installation site inspected and seek the advice of a professional in instances
where increased noise may cause a nuisance.

Transport

The tumble dryer and heat-pump must be separated from one another before being trans-
ported. The machines may be damaged if they are transported without being separated.
The tumble dryer and the heat-pump may not be transported without transport pallets.
Suitable transport aids must always be used during transportation.
Tilting the heat-pump by more than 30° should be avoided as much as possible.
After the heat-pump has been transported, it should be left for approximately one hour be-
fore commissioning. If the heat-pump is subjected to especially strong vibrations or is tilted
by more than 30°, downtime can increase by up to 24 hours.
150