Shutting Off The Engine; Recycling The Clippings; Bagging The Clippings; Operating The Bag-On-Demand Lever - Toro Recycler 20960 Bedienungsanleitung

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
14).

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove
it; refer to
14). If the bag-on-demand lever is in the recycling
position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page
Installing the Grass Bag
1. Raise and hold up the rear deflector
14). If
1. Rear deflector
2. Notches (2)
2. Install the grass bag, ensuring that the pins on
the bag rest in the notches on the handle
17).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
Grass Bag (page
13
Removing the Side-Discharge Chute (page
Figure 17
3. Grass-bag pin (2)
13).
14).
(Figure 17).
g033379
(Figure
Installing the