Cleaning And Storing The Unit; Error Messages/Troubleshooting - Beurer BM 57 Gebrauchsanweisung

Step 1: BM 57
Activate Bluetooth
chapter 4 "Preparing the measurement, Blue-
tooth ").
®
Step 2: Beurer "HealthManager" app
In the Beurer "HealthManager" app, add the
BM 57 under "Settings/My devices".
Step 3: BM 57
take a measurement.
Step 4 BM 57:
data transfer immediately
following measurements.
• If Bluetooth data trans-
®
fer has been activated,
data is transferred after
having confirmed the user
memory and pressing the
START/STOP button
on your device (see
®
Step 4 BM 57:
Data transfer at a later point:
• Go to memory mode
(chapter 7). Select the
desired user memory. The
Bluetooth transfer starts
®
automatically.
.
The Beurer "HealthManager" app must be active to allow
data transfers.
If your smartphone has a protective cover, remove this to ensu-
re that there is no interference during the transfer. Begin the
data transfer in the Beurer "HealthManager" app.

8. Cleaning and storing the unit

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under wa-
ter, as this can cause liquid to enter and damage the unit.
• If you store the device, no heavy objects should be placed on
top of it. The cuff line should not be bent sharply.
In such cases, repeat the measurement and/or data transfer.
Ensure that the cuff line is correctly attached and that you do
not move or speak during the measurement.
The Bluetooth word mark and logos are registered trade-
®
marks owned by Bluetooth
marks by Beurer GmbH is under license. Other trademarks and
trade names are those of their respective owners.

9. Error messages/troubleshooting

In the event of errors, the error message
display.
Error messages may appear if:
• Systolic or diastolic pressure could not be measured (
• The cuff is faulty or fastened too tightly or too loosely (
• The pump pressure is higher than 290 mmHg (
• The data could not be sent via Bluetooth
30
SIG, Inc. and any use of such
®
appears on the
( )
®
)
)
)