Operating The Machine; Normal Operation; Inserting The Wire; Touch Display And Operating Menus - Weidmuller Crimpfix R Originalbetriebsanleitung

6

Operating the machine

6.1 Normal operation

► Inset the wire-end ferrule reel.
► Things to check prior to each activation:
– Is the power cable in fault-free condition?
– Is the required operating pressure of
5.5 bar present?
– Is the front plate closed?
► Switch on the mains switch.
The valves audibly start up and a reference run is execut-
ed. The touch display shows readiness for operation.

6.2 Inserting the wire

Only process wires that are cut cleanly. All
stranded wire must finish with the insulation.
No stranded wire may be shortened or protrude.
Ensure that the end of the wire is inserted
evenly.
40 mm
Figure 6.1 Insert the wire correctly
LZ:
► Insert a wire into the insertion funnel.
The material is drawn in slightly and processed automati-
cally. Valve noises are audible during this process.
► Once the processing is complete (no more noises), pull
the processed wire out.
2549630000/00/09.2017

6.3 Touch display and operating menus

The touch display indicates the current operating condition.
The lower part of the display is touch-sensitive.
You can navigate through the program using the four con-
trol buttons.
Figure 6.2 Touch display; display following activation
Button Functions
 Select menu (move forwards) or increase value
 Select menu (move backwards) or reduce value
C
Exit menu (back to menu 1)
E
Activate selected menu or set value
► To select an operating menu, press the arrow keys.
► To switch to the selected menu, press E.
► Move to the desired point inside a menu using the arrow
keys.
► To activate a selected point, press E.
► To exit the menu, press C.
Only menus 1, 3 and 10 are relevant for operation. Here
you can:
Menu 1: Reset the day's piece quantity
Menu 3: Change operating mode (standard: crimping and
stripping)
Menu 10: Set language
The remaining menus are only intended for servicing.
35