Waeco PerfectView CAM60ADR Einbau- Und Bedienungsanleitung Seite 32

Mounting the camera
If you would like to attach the camera with threaded screws fitted
through the construction (fig. a, page 6)
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell
when they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig. b, page 6)
I
NOTE
If possible, use available openings – such as ventilation grilles –
to feed the connection cables through. If there are no existing
openings, you must drill a hole with a 16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill
head to come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Mounting the camera
A
NOTICE! Risk of damage!
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Push the camera into the camera bracket.
➤ Attach the camera loosely with the two screws M3 x 8 mm in the slots
(fig. c, page 6).
32
PerfectView CAM60ADR
EN