Battery Charging - piomic COMS One Gebrauchsanweisung

4. BATTERY CHARGING

1
2 3
10
The charger has not been IP tested. Please charge device at a
dry location.
The USB cable can only be used for charging COMS One
with the charger and COMS One shall not be connected to
computers or other devices with the USB-cable.
1. Select plug matching your wall outlet and attach it to the
charger (initial use only).
CAUTION
• Do not apply the device while it is charging. Non-
observance can lead to electric shocks.
4
• Do only use the original power supply certifi cated
with IEC 62368-1 and USB cable for charging.
Using other power supplies or cables may result in
electric shock or electromagnetic interference that
prevents the device or other devices from operating
properly.
2. Plug the charger into a wall outlet and attach the USB
cable to the COMS One power supply and the COMS
One.
3. The battery indicator will indicate charging. During
charging the light below the battery symbol will be blink-
ing green. When the battery is fully charged the battery
indicator will stop blinking and indicate battery full with
a solid green light.
It takes approximately 2 hours to fully charge the device.
When the device is fully charged, it has enough power for at
least 6 treatments. The battery has an expected lifetime of 3
years. After 3 years of intensive usage, it may no longer be
suffi cient for 6 treatments with one charge.
Remove the charger from the wall socket and pull the USB
plug out of the USB socket to disconnect device from the
mains supply.
Therefore charger and device must be placed easily access-
ible. Let the device rest 5 minutes after charging.