Display Functions; User Settings - PowerWalker VFI ICT IoT Benutzerhandbuch

4.3 Display functions

When starting the UPS, the display is in the default UPS status summary screen.
Main menu Submenu
UPS status
Event log
Measurements
Go to Bypass
Load segment
Start battery test
Control Reset fault state
Reset event list
Reset com card
Restore factory settings
Settings
Identification

4.4 User settings

Submenu
Password
Change language
User password
Audible alarms
Output voltage
Output frequency
High efficiency mode
Auto bypass
Start/Auto restart/Start
from bypass
Site wiring fault
Display information or Menu function
UPS mode, IoT status, date/time, battery status and
current alarms
Displays the events and faults stored
[Load] W VA A P%, [Input/Output] V Hz,
[Battery] % min V EBM, [DC Bus] V, [Temperature] C
Transfers the UPS on Bypass mode
Load segment on/off
Starts a manual battery test
Clear active fault
Clear events and faults
Reset com card inside UPS
Restore to default factory settings
Refer to
[Product name], [Serial number], [firmware
version], [IP/MAC address]
Available settings
Can be changed by user
English, Italiano, Français, Deutsch, Español,
Русский, Polski, 简体中文
[enabled, ****], [disabled]
[enabled], [disabled]
[200V], [208V], [220V], [230V], [240V]
[autosensing], [converter 50Hz, 60Hz]
[disabled], [enabled]
[disabled], [enabled]
[disabled], [enabled]
[enabled], [disabled]
19
chapter 4.4 User settings
Default settings
4732
English
enabled
enabled
[230V]
[240V] for AU
autosensing
disabled
disabled
Cold start/Auto restart:
enabled
Start from bypass:
disabled
disabled