HEIDELBERG Suprasetter 106 Installationsanleitung Seite 43

Fig. 47 EMC seal
Fig. 48 Safety loop and remote-on cable
Fig. 49 Remote-on cable X127
DCL für Suprasetter 106 – Installation
Route the remote-on cable and the cable for the
safety loop past the outside of the EMC gasket
(Fig. 47/1) as far as the electronics.
Pull off the jumpers X132 and X135 (Fig. 48/1) and
connect the connectors X132 and X135 (Fig. 48/2)
for the safety loop.
Fit the connector of the remote-on cable X127 (Fig.
49/1).
Fasten the adapters to the cable harness with
cable ties.
Installation
41