Installation
Fig. 32 Parallelism of suction bar to tray
After that check whether the suction bar is aligned parallel to the tray (Fig. 32) and check the delivery
points again.
Note: If the loader is not level and the suction bar and tray are not aligned parallel to each
other, a plate can also be subject to suctioning during paper separation.
Before you fit the covers, check the load mechanism with the debug program and, if necessary, set it
(see the section
"Checking / Setting of the Load Mechanism", page
Fig. 33 Gap 6 mm
34
45).
Close the cover. The gap between the recorder
cover (Fig. 33/1) and the separator cover (Fig. 33/
2) is to be approx. 6 mm.
07/2019