Installation
Fig. 41 Power cable in the Suprasetter
Damage to power cable
The power cable must be routed with extreme caution when going from the sep-
arator to the interior of the loader because it can be damaged from the motion of
the lift table.
Fig. 42 Route power cable
38
Power cable
The power cable for the loader is to be found
coiled in the Suprasetter (Fig. 41/1).
NOTICE
Pull out the power cable and route it to the loader
through the tie-bar (Fig. 42/1). Run it through the
separator down into the loader. Route it along the
cable harness as far as the electronics and plug it
on X1 (Fig. 42/2 and Fig. 43). Secure the power
cable with cable ties.
07/2019