Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Connection

Establish drain for water
WARNING!
Risk of scalding!
Improper handling of the appliance can
lead to scalding caused by soapy water.
Fix the hose to the sink or bath to pre-
vent it from slipping due to the recoil
caused by pumping.
For drains, make sure that the cross
section of the discharge pipe is great
enough that the sink cannot overfl ow.
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
Use only the water outlet hose pro-
vided.
Do not extend the water outlet hose
or replace it with another hose.
The water outlet hose must not get
bent or twisted.
The bend on the water outlet hose
should be no more than 100  cm
above the ground to ensure that wa-
ter can be drained off properly.
The water outlet hose must be in the
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.
You can fit the outlet hose in two ways:
Installation, connection and initial commissioning
Fixing with a hose holder
• Put the end of the water outlet hose (18)
Attaching the discharge manifold to a
washbasin
• The water outlet hose (18) is mounted
water can run out. This washer must be
replaced by a seal ring before connecting
the water outlet hose.
over a hose holder and hang it over the
edge of a bath. You can find a hose hold-
er in a specialist shop or DIY store.
onto a special device, which can be found
on the outlet manifold of a washbasin. In
doing so the lock on the siphon must be
removed.
Have this fixed by a specialist!
There is a washer in an unused con-
nection manifold to ensure that no
Page EN-33

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis