Getting Started - hanseatic HWM8T3l16C Gebrauchsanleitung

Getting started

Before getting started
• First read chapter "Intended use" and
chapter "Use the appliance only as de-
scribed in this user manual. Any other
use is deemed improper and may result
in damage to property or even personal
injury. The manufacturer accepts no liabil-
ity for damage caused by improper use."
(see page EN-4 and the following).
• Remove the transport safety devices and
prepare the appliance as described in
chapter "Installation, connection and initial
commissioning" (see page EN-31).
• Properly attach the water inlet hose (34)
and the water outlet hose (18).
Possible residual water or drops in the
appliance are merely a sign that it was
tested for functionality during production.
The appliance requires an initial wash cycle
without laundry, but with detergent (test run).
The aim of this is to rinse out possible resi-
dues from production.
1. Check whether the water inlet hose and
water outlet hose (18) are securely con-
nected.
2. Open the valve completely.
3. Make sure that the drum is empty.
4. Push the loading door (15) tightly closed.
(21)
(1)
5. If the partition (21) is located in the left
chamber II of the dispensing drawer (1),
take it out. Keep it safe as it is needed
when liquid detergent is used.
Installation, connection and initial commissioning
6. Dispense a maximum of 25 ml of compact
7. Set the cycle selector (2) to the "Cotton"
8. Press the
9. Turn the cycle selector (2) to "Off". Take
Start-up is now finished.
detergent into left chamber II.
(2) (4)
cycle.
The cycle time is shown in the display (4).
button (7).
The cycle starts and the remaining cycle
time is shown in the (4) display.
After the cycle is finished, "End" is shown
in the display (4).
the mains plug out of the socket and turn
off the tap.
Page EN-35
(7)
Schnell