Descale The Appliance - Atag CM46 D Serie Bedienungsanleitung

MAINTENANCE

Descale the appliance

Descale the appliance when the related message is shown on the display.
• To descale immediately, read and obey the instructions shown on the display.
• To descale the appliance later, touch the escape key.
A symbol is shown on the display to remind you that the appliance needs descaling.
▷
Important!
Before use, read the instructions and the labelling on the descaler pack. You should
use descaler authorised by the manufacturer only. Using unsuitable descaler and/or
performing descaling incorrectly may result in faults not covered by the manufacturer's
warranty.
Danger of burns!
Hot water containing acid flows out of the hot water spout. Take care to avoid contact
with splashes of this solution.
Please note
• A series of rinses and pauses is performed automatically to remove all the scale
residues inside the coffee machine. Empty the container every time after it has collected
the rinsing water.
• If a filter was removed previously, the display will show the message when to insert the
filter into the housing. If no filter was present, you can skip this step.
• If the descaling cycle is not completed correctly (e.g. no electricity) we recommend
repeating the cycle.
• If the water tank has not been filled to the MAX level, at the end of descaling, the
appliance requests a third rinse to guarantee that the descaler solution has been
completely eliminated from the appliance's internal circuits. Before starting rinsing,
remember to empty the drip tray.
• The appliance may request descaling cycles at very short intervals. This is normal due
to the appliance's advanced control system.
EN 26