Atag CM46 D Serie Bedienungsanleitung Seite 77

TROUBLE SHOOTING
Problem
Coffee does not come out of
one or both of the spouts.
The appliance does not make
coffee.
The appliance does not come
on.
The brewing unit cannot be
removed.
The appliance makes a weird
sound (not as normal).
At the end of descaling, the
appliance requests a third
rinse.
The milk does not come out
of the milk spout.
The milk contains large
bubbles and squirts out of
the milk spout or there is little
froth.
Possible cause
The coffee spouts are
blocked.
The appliance has detected
impurities in its internal
circuits. See the information
shown on the display.
The appliance is not set to
'On'.
The appliance has not been
set to 'Standby' correctly.
The drip tray has not been
removed.
The brewing unit is not in the
correct position.
The brewing unit and the
infuser are dirty.
During the two rinse cycles,
the water tank has not been
filled to the MAX level.
The lid of the milk container
is dirty.
The milk is not cold enough
or is not semi-skimmed or
skimmed.
The milk froth adjustment
knob is incorrectly adjusted.
The lid of the milk container
or the milk froth adjustment
knob is dirty.
The hot water connection
nozzle is dirty.
Remedy
Clean the coffee spouts.
Wait for the appliance to be
ready for use again and select
the required beverage again.
Push the main switch to set
the appliance to 'On'.
Push the On button to set the
appliance to 'On'.
Push the Standby button
to set the appliance to
'Standby'.
Remove the drip tray.
Close the door and set
the appliance to 'On'. The
brewing unit automatically
returns to the correct position.
Clean the infuser and all
parts of the brewing unit.
Lubricate the o-rings with the
lubricating grease.
Obey the instructions shown
on the display.
Clean all components of the
milk container.
Use skimmed or partially
skimmed milk at refrigerator
temperature (about 5 °C). If
the result is not as you wish,
try changing brand of milk.
Adjust the milk froth
adjustment knob.
Clean all components of the
milk container.
Clean the nozzle.
EN 37