Cameo ROOT PAR 4 Bedienungsanleitung Seite 18

Settings
Disp Rev = Rotate display
Disp Back = Display lighting
Sig Fail = Operating status
Sound = Sets music
PWM = LED PWM
Calibration = Color calibration
(CLROOT-
PAR4)
Calibration = Color calibration
(CLROOT-
PAR6)
IR Remote = Activate or deacti-
Reset = Reset settings
Edit Preset = Store all system
Service = For service purposes only
18
No
Yes
Off
On
Hold
with DMX signal
Black
fault
User 1
Last
control
Off
650 Hz,
frequency 1530 Hz,
2150 Hz,
4000 Hz
Red, Green,
Blue, White
Red, Green,
Blue, White,
Amber, UV
On
vate control by IR
Off
remote control
Factory
Preset A
Preset B
Preset C
Preset A
settings in 3
Preset B
individual presets
Preset C
No display rotation
Display is rotated by 180°
(e.g. for overhead installation)
Deactivates after approximately 30
seconds of inactivity
On permanently
Last command is retained
Activates blackout
User Color 1 is activated
Color is retained until next impulse
Color expires after a moment, until next
impulse
Select LED PWM frequency
Individual color calibration. Cross-mode
brightness setting of the 4 LED groups
RGBW with values from 0 to 255
Individual color calibration. Cross-mode
brightness setting of the 6 LED groups
RGBWA+UV with values from 0 to 255
IR remote control activated
IR remote control deactivated
Reset to factory settings: Perform
reset with ENTER, cancel with MENU
Reset to Preset A: Perform reset with
ENTER, cancel with MENU
Reset to Preset B: Perform reset with
ENTER, cancel with MENU
Reset to Preset C: Perform reset with
ENTER, cancel with MENU
Store with ENTER
Store with ENTER
Store with ENTER