Cameo ROOT PAR 4 Bedienungsanleitung Seite 5

3. Simply pressing the On/Off switch on the device is not enough to entirely
disconnect the device from the power supply.
4. Make sure that the fuse used corresponds to the type shown on the device.
5. Make sure that suitable measures have been taken to prevent power surges
(e.g., lightning strike).
6. Observe the specified maximum output current on devices with a Power Out
connection. Ensure that the total power consumption of all devices connected to
the device does not exceed the specified value.
7. Replace plug-in power cords only with cords that are comparable to the originally
supplied cords. The cross-section must not fall below the cross-section of the
original cord.
DANGER:
1. Risk of suffocation! Plastic bags and small parts must be kept out of reach of persons
(including children) with reduced physical, sensory, or mental capabilities.
2. Fall hazard! Make sure that the device is securely installed and cannot fall down.
Only use suitable stands or mountings (especially for fixed installations). Make sure
that accessories are properly installed and secured. Ensure that applicable safety
regulations are observed when doing this.
WARNING:
1. Only use the device as properly intended.
2. Only operate the device with accessories recommended and provided by
the manufacturer.
3. Please observe the safety regulations in place in your country when installing
the device.
4. After the device is connected, check all cable paths to prevent any damage or
accidents (e.g., tripping hazards).
5. Please observe the specified minimum distances to materials with normal
flammability! Unless explicitly stated, the minimum distance is 0.98 ft.
6. Always observe the minimum distance to the illuminated surface to be read
on the device!
CAUTION:
1. Moving components such as mounting brackets or other moving components may
become trapped.
2. In the case of devices with motor-driven components, there is a risk of being injured
by the moving device. Sudden device movements can lead to startle responses.
3. The device's housing surface can get very hot during regular operation. Make sure
that unintentional contact with the housing cannot happen. Always allow the device to
cool sufficiently before disassembly, maintenance work, and charging, etc..
5