Preparation; Installation Location; Installation; Wall Mounting - STIEBEL ELTRON CK 20 Trend LCD Bedienungsanleitung

INsTALLATIoN

Preparation

11. Preparation

11.1 Installation location

Minimum clearances
≥500
≥10
CAUTION Injury
!
f Maintain the minimum clearances. f
f If you are using the appliance together with a towel f
rail, fit the appliance so that the towel rail is at least
600 mm above floor level.
Note
For efficient heating (without towel rail), we recommend
an installed height of between 300 and 500 mm.
Note
The dust filter is 275 mm wide.
- To enable removal of the dust filter as described (see
chapter "Cleaning, care and maintenance"), maintain
a sufficiently large clearance at the side.
- If you have installed the appliance in a recess, de-
tach the appliance from the wall mounting bracket
before removing the dust filter.
12. Installation

12.1 Wall mounting

Note
Secure the wall mounting bracket with the tab cut-out
pointing upwards.
Note
Use appropriate fixing materials.
22 | CK 20 Trend LCD
≥100 ≥100
1 Wall mounting bracket
f Mark out the holes to be drilled for the wall mounting brack- f
et on the wall. Use the wall mounting bracket as a template
for this purpose.
f Drill the holes. f
f Secure the wall mounting bracket horizontally to the wall f
with suitable rawl plugs and screws.
Note
The horizontal and vertical slots enable an adjustment in
case the fixing holes are not quite where they should be.

12.2 Appliance installation

1 Wall mounting bracket
f Hook the appliance with the upper vertical recesses of the f
back panel onto the wall mounting bracket.
1
1
www.stiebel-eltron.com