Installation In A Double-Hung - Electrolux EXP09HN1W6 Benutzerhandbuch

4.2 WALL DISCHARGE
Mount wall adaptor directly over correctly
installed duct to outside. (This usually
includes aluminum wall ducting & an
outside cover. See your hardware special-
ist for correct installation.) Use wall plugs
& screws to secure. (Fig. 10) Attach hose
duct to wall adaptor.
Wall
adaptor a
Screws
& Wall
Plugs Plu
Fig. 10
The hose can be extended from its original
length of 38.1cm up to 139.7cm, but it is
the best to keep the length to minimum
required. Also make sure that the hose
does not have any sharp bends or sags.
(Fig. 11)
Fig. 11

4.3 Installation in a double-hung

sash window
1. Cut the foam seals(adhesive type) to the
proper lengths and attach them to the
window and stool. (Fig. 12)
Fig. 12
2. Open the window sash and place the
150mm
Max 48"
Min 12"
Fig. 13
Fig. 14
3. Close the window sash securely against
4. Drive two 1/2" screws to secure the
5. Secure the window slider kit to the
Foam seal A
(adhesive type)
Fig. 15
window slider kit on the window stool
(Fig. 13). Attach the window slider kit to
the window stool. Adjust the length of
the window slider kit according to the
width of window. Screw down the two
screws on the window slider kit. See
Fig.13. Cut the adjustable window slider
kit if the width of window is less than
26.6 inches (Fig. 14).
screws
26.6"~48.5"
Window stool
Cut this side to fit your window
the window slider kit. (Fig. 15)
window slider kit to the window sash.
(Fig. 15)
window stool (Fig. 15):
A: For wooden windows: Use 3/4"
screws for securing.
B: For Vinyl-Clad windows: Use
1/2" hex head cap screws for
securing.
1/2" screws
3/4" screws or 1/2"
hex head cap screws
Window stool
ENGLISH 27
Window slider kit
Window slider kit