Installation Instructions - Electrolux EXP09HN1W6 Benutzerhandbuch

26 www.electrolux.com

4. INSTALLATION INSTRUCTIONS

4.1 Exhausting hot air window
discharge
In the COOLING Mode the appliance must
be placed close to a window or opening
so that the warm exhaust air can be
ducted outside. First position unit on a flat
floor and make sure there's a minimum of
30.5cm clearance around the unit, and is
within the vicinity of a single circuit outlet
power source.
1. Take the hose out from the packaging. T T
(Fig.3).
Fig. 3
2. Remove adaptor A from unit by sliding
upwards (Fig.4).
Fig. 4
3. Extend either side of the hose (Fig. 5)
and screw the hose to adaptor A
(Fig. 6).
Fig. 5
Fig. 6
Slide upwards
Extend the side of hose
4. Extend the other side of the hose and
screw it to adaptor B (Fig. 7).
Fig. 7
5. Slide the assembly onto unit (Fig. 8).
Fig. 8
6. Affix the adaptor B into the window f f
slider kit and seal. (Fig. 9a&9b)
Vertical
window
Window Slider Kit
Minimum: 67.5cm (26.6")
Maxmum: 123cm (48.5")
Fig. 9a
Horizontal
window
Window Slider Kit
Minimum: 67.5cm (26.6")
Maxmum: 123cm (48.5")
Fig. 9b