IGM Professional FKP656-set Gebrauchsanweisung Seite 5

Operating instructions EN
Boring holes into the side
Tighten a metal stop into the hole at the jig edge. Place the FKP on the workpiece so that the edge
stop is touching the front side of the workpiece and the tightening flanges are oriented to the reverse of the
workpiece (fig.8).
Ensure that the stop is touching the front side of the board and the inner parts of the jig are abutting on the
workpiece. Tighten the FKP by the tightening flanges. Tighten the screws by hand with optimal power - for
sufficient tightening no excessive power is needed. Remove the stop ring FKP101-8 from the boring bush. Thus
you will change the boring depth at 22 mm (fig. 8). Put the boring bush with respective dowel bit into the
holes and bore dowel holes (fig. 8). Bore rather deep holes on multiple pass, so that the cuttings can be well
evacuated. Keep the correct revolutions direction - dowel bits are delivered in right-handed construction.
Producing of longer joint than the jig
The working procedure is represented in the figure (fig. 9).
The edge stop removed, the boring jig can be shifted along the workpiece side. To hold the last hole and
keep the 32 mm spacing, use a centering pin. The boring jig is delivered with a centering pin for 8 mm dowel
diameter. The procedure is the same as when boring with the edge stop, the jig position on the workpiece is
ensured by the centering pin.
Warning !!!
While boring, press the boring bush to the jig to keep the perpendicularity. You can support the boring
bush with the other hand. Always keep the drilling machine perpendicular so that the boring bush is touching
FK with its entire surface. It is better to bore holes on multiple pass. Always follow the safety instructions
for work with the drilling machine!
d=8mm
A
A
FKP101
FKP101
d=8mm
B
fig. 9
min.22mm
A
fig. 8
www.igmtools.com
5