Angular Joint Producing - IGM Professional FKP656-set Gebrauchsanweisung

Operating instructions EN
Setting of boring depth FKP101, 102
The setting procedure is represented in the figure (fig. 5). For simple boring dowels of 35 mm length, use the
FKP101-8 ring (from 1.8.2010 included in the sets). Insert the FKP ring under the spring stop (fig. 3). Tighten the
workpiece to the jig. The setting is made on the upper surface of the jig. Put the boring bush into the 18 mm
diameter holes so that after pressing onto the shank, the point of the dowel bit touches the workpiece. Loosen
the setting stop ring screw (imbus key 2 is included in FKP101-102 packing) and press the stop ring to the jig
until the stop ring touches the spring stop (fig. 5A). The zero point for the boring depth setting is thus set. The
boring depth for boring into surface, which is now 15 mm, is set between the stop ring and the spring stop.
The boring depth set, tighten carefully the screw of the stop ring considering the screw diameter (fig. 5 C). At the
boring bush FKP101, this value can be read with the help of lines at the shank, distance of lines is 5 mm (fig. 3).
The stop ring is designed so that the side boring depth is 2 mm longer than the total dowel length, which is 35 mm
(reserve for the glue).
C
B
A
2.
1.
fig. 5

ANGULAR JOINT PRODUCING

Dividing up of the cupboard elements is represented in the figure (fig. 6).
-Before boring always check whether the inner part of the jig is perfectly touching the workpiece.
-Always adjust the workpiece from the front side on and when boring hole into the side the tightening
flanges must be oriented to the reverse of the workpiece, never contrariwise!! Thus you ensure a 0,5mm
facet.
-Check the boring depth before boring.
-If the bored hole isn't clean the dowel bit must be grinded.
-If the hole isn't deep enough, set longer boring depth on the boring bush FKP101.
Boring holes into the surface
Tighten a metal stop into the hole at the jig edge. Place the FKP on the workpiece so that the edge stop
is touching the front side of the workpiece and the surface A of the jig is oriented to the reverse of the
workpiece (fig. 7).
FKP101
0,5mm
B
8mm
35mm
A
B
fig. 6 fig. 7
www.igmtools.com
4