Thomashilfen Hercules XL Gebrauchsanweisung Seite 40

Instructions for Use – Hercules XL
You can put aside the unused mounting kit ("A" or "B").
You can find detailed instructions in our assembly video on the Internet:
www.thomashilfen.de/hercules-xl-montage
Headrest
Assembly tip: To attach the headrest, hold the upholstery slot open with a spacer.
(fig. 22)
When mounting the headrest, the threaded rod must be at the bottom.
To adjust the headrest, loosen the screw that holds the headrest. Then the height of
the headrest is adjusted to the user and tightened again. (fig. 23) Make sure that the
back of the user's head is centred in the headrest.
The headrest is attached to a ball joint. The headrest can be finely adjusted by loosen-
ing the screws under the upholstery. The headrest must be removed for this.
Lateral trunk supports, rigid / swing-away
The brackets of the lateral trunk supports are guided through the openings of the back
pads on the left and right and screwed to the back plate in the position suitable for the
user.
The rigid lateral trunk supports are attached with two screws starting from the back of
the back plate. (fig. 24+25)
The screws for the swing-away lateral trunk supports are inserted through the back
in the desired position from the front and secured from behind with two nuts.
(fig. 26+27)
Attention: Lateral trunk supports and upper body supports cannot be used simultane-
ously!
Abduction block
The holder for the abduction block is positioned on the upper side of the seat depth
plate and screwed from below. (fig. 28)
The abduction block is guided into the holder with the square tube and locked at the
desired height with the toggle screw. (fig. 29)
40
2021-04