Displays; Operator Display; Drawer Lock Key - Sharp XE-A202 Bedienungsanleitung

A202_1 03.7.5 8:06 AM
5

Displays

Operator display

PLU/SUB
DEPT REPEAT
RCPT
OFF
Amount:
Number of repeats for repetitive registrations:
Receipt function status:
Time:
Machine state symbols
: Appears during programming.
: Appears when an error is detected.
: Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount.
: Appears when the
: Appears when a transaction is finalized by pressing the
: Appears when the change due amount is displayed.
: Appears in the far-left three positions at the timing of key entry when the electronic journal (EJ) memory
is full. (Depending on programming.)
: Appears when the voltage of the installed batteries is under the required level. You must replace with
new ones within two days. Refer to page 64 for details.
: Appears when the batteries are not installed, or the installed batteries are dead. You must replace with
new ones immediately. Refer to page 64 for details.
: May appear right below the eighth and ninth places at the timing of finalization of a transaction when the
electronic journal (EJ) memory is nearly full.
Also appears right below the tenth place when power save mode is effective.
: Appears when programmed date (and time) for EURO modification operation is come.
: Appears when the print roller arm is not locked.
6

Drawer Lock Key

This key locks and unlocks the drawer. To lock it, turn 90
degrees counterclockwise. To unlock it, turn 90 degrees
clockwise.
6
Downloaded from: http://www.usersmanualguide.com/
Page 6
Clerk code
DC SHIFT NUMBER
Appears in the far-right eight (max.) positions. When the amount is negative, the minus symbol "-"
appears before the amount.
The number of repeats is displayed, starting at "2" and incremental with each repeat. When you
have registered ten times, the display will show "0."(2
The indicator "_" appears in the RCPT OFF position when the receipt function is in the OFF
status.
Appears in the second to sixth positions (using 24-hour format) in the OP X/Z, REG or MGR
mode. In the REG or MGR mode, press the
V
key is pressed to calculate a subtotal in foreign currency.
: Appears when the paper is not set or out.
Customer display (Pop-up type)
→ 3 ..... 9 → 0 → 1 → 2 ... )
s
key to display the time.
A X Y
, , ,
c b
or key.