Sharp XE-A202 Bedienungsanleitung Seite 48

A202_3 FOR THE MANAGER
Compression print on journal at REG, MGR and VOID modes
• This selection is valid only when "Printing style" (job code 6) is set as "journal printing".
Job code: 67
* Item:
A Rounding amount printing
B Total amount rounding when a transaction
is finalized directly by
C Rounding up of the unit digit of amount
D Rounding down of the unit digit of amount
E Application of rounding
F Limit of the least significant digit in
entering amount of item
G Memory of difference due to rounding
H Limit of the least significant digit in
entering amount of payment
Rounding amount printing (A)
Total amount rounding when a transaction is finalized directly by
• When you live in Australia, set as shown on the tale below for the parameters A and B.
Rounding up of the unit digit of amount (C)
Rounding down of the unit digit of amount (D)
• Handle C and D as a pair. When you live in Australia, Switzerland, Norway or South Africa set as shown on
the table below for the parameters C and D.
The rounding is performed as follows:
In case C = 0: Unit digit of amount < or = Value of D — rounding down
In other cases: Unit digit of amount < or = Value of D — rounding down
Application of rounding (E)
Limit of the least significant digit in entering amount of item (F)
Memory of difference due to rounding (G)
Limit of the least significant digit in entering amount of payment (H)
• When you live in Australia, Switzerland, Norway or South Africa set as shown on the table below for the
parameters E through H.
Switzerland
Norway
South Africa
Australia
* Applied to payment by cash and change amount.
46
Downloaded from: http://www.usersmanualguide.com/
03.7.5 8:08 AM Page 46
X Y c b
, , or
Value of D < or = Unit digit of amount — rounding to 5
Value of D < Unit digit of amount < Value of C — rounding to 5
Value of C < or = Unit digit of amount — rounding up
CD E
82 Item & payment
54 Payment
05 Payment
A B CD
Yes Not rounding 82
Selection:
No*
Yes (for Australian system)
Rounding*
key. Not rounding (for Australian system)
Item and payment*
Payment
Arbitrary*
0 only
0 and 5 only
No*
Yes
Arbitrary*
0 only
0 and 5 only
X
,
F
0 and 5 only
Arbitrary
Arbitrary
E F
Payment* Arbitrary
Entry:
0
1
0
1
0 - 9 (default: 0)
0 - 9 (default: 0)
0
1
0
1
2
0
1
0
1
2
Y c b
, key(B)
or
G H
No 0 and 5 only
Yes 0 only
Yes 0 and 5 only
G H
Yes 0 and 5 only