Item Entries; Single Item Entries - Sharp XE-A202 Bedienungsanleitung

A202_2 FOR THE OPERATOR
3

Item Entries

Single item entries

1. Department entries
The cash register provides a maximum of 50 departments for a merchandise classification. Group attributes,
such as taxable status, are applied to items when they are entered to the departments.
• When using the department keys (for department 1 to 32)
For department 1 to 16, enter a unit price and press a department key. If you use a programmed unit price,
press a department key only.
For department 17 to 32, enter a unit price, press the
programmed unit price, press the
When using a programmed unit price
Unit price *
(max. 8 digits)
• When using the department code entry key
Enter a department (dept.) code and press the
you use a programmed unit price, enter a dept. code and press the
Dept. code
(1 to 50)
2. PLU/subdepartment entries
For another merchandise classification, the cash register provides a maximum of 1200 PLUs/subdepartments.
PLUs are used to call up preset prices by a code entry. Subdepartments are used to classify merchandise into
smaller groups under the departments. Every PLU and subdepartment has a code from 1 to 1200, and should
belong to a department to obtain attributes of that department.
By default, the cash register is preprogrammed to be able to use 1 to 200 codes, and these 200 codes are set to
PLU mode and zero for unit price.
To extend the number of PLU codes to 1200, please refer to "EJ memory type" on page 41, and for other
PLU/subdepartment programming, refer to "PLU and Subdepartment Programming" on page 29.
14
Downloaded from: http://www.usersmanualguide.com/
03.7.5 8:06 AM
D
1
2
*
D
Please note if you press the same key after using the
example, when you register an item of dept. 17 using the
using the preset unit price, you should use the department code entry key described below for the
dept. 1 item. If you just press the
dept. 17 item.
When using a programmed unit price
d
1
Unit price *
(max. 8 digits)
(In case only preset price entry is allowed.)
Page 14
D
key and press a department key. If you use a
key and press a department key.
* Less than the programmed upper limit amounts
1
Department key
When zero is entered, only the sales quantity is
added.
* For the departments 17 through 32, press the
2
D
D
D
!
key to register dept. 1 item, it will act as a repeat entry of
d
key, then enter a unit price and press the
d
*
d
key.
key, it acts as a repeat entry. For
key and then an item of dept. 1
d
key again. If
key.
Less than the programmed upper limit
1
amounts
When zero is entered, only the sales
quantity is added.