Fuse Replacement; Maintenance And Cleaning - VOLTCRAFT MSW 150 Bedienungsanleitung

9. fuSE rEPLaCEMENT

If the fuse in the cigarette lighter of the inverter has tripped, it must be replaced as follows:
• Disconnect the consumer from the inverter, pull the mains plug of the consumer from the
socket of the inverter.
• Pull the cigarette lighter plug of the inverter from the cigarette lighter socket.
• Remove the cause that tripped the fuse. This may be a connection with swapped polarity or
a consumer connected to the inverter with a too-high power consumption.
• Open the cigarette lighter plug by unscrewing the knurled nut at the tip of the plug.
• Replace the defective fuse by a new one of the same build. Observe the print on the fuse or
the chapter "Technical Data".
• Screw together the cigarette lighter plug, tighten the knurled nut by hand.
• The inverter can now be put into operation again.

10. MaINTENaNCE aNd CLEaNINg

The product does not require any maintenance. You should never take it apart.
The product should only be repaired by a specialist or specialist workshop or it may be dam-
aged. Furthermore, the CE approval and the guarantee/warranty will expire.
Before cleaning, switch off the product and disconnect it from the voltage/current supply.
Disconnect any connected consumer as well.
Only clean the product with a soft, clean, dry and lint-free cloth. Never use any cleaning
agents, since this might damage the surface of the casing and label.
Dust can be removed using a clean, soft brush and a vacuum cleaner.
36