Fuse Replacement; General Information About Operating Electrical Loads On Voltage Inverters; Care; Disposal - VOLTCRAFT MCI 150-12 Bedienungsanleitung

TABLE DES MATIÈRES
Introduction .............................................................................................................................. 21
Table des matières .................................................................................................................. 22
1. Utilisation prévue .............................................................................................................. 23
2. Contenu d'emballage ....................................................................................................... 23
3. Consignes de sécurité ...................................................................................................... 24
4. Utilisation .......................................................................................................................... 26
5. Depannage ....................................................................................................................... 27
6. Remplacement des fusibles ............................................................................................. 28
Informations générales sur le fonctionnement des appareils électriques dans les
7.
chargeurs de tension ........................................................................................................
8. Précautions d'emploi ........................................................................................................ 28
9. Elimination des déchets .................................................................................................... 29
10. Caractéristiques techniques ............................................................................................. 29
22
6.

FUSE REPLACEMENT

Page 1. Unplug the inverter from the cigarette lighter outlet and disconnect the electrical load.
2. Rotate tip of the inverter carefully anticlockwise to open the fuse compartment.
3. Replace the blown fuse with a new one of the same type (please refer to "Technical Data").
4. Close the fuse compartment.
7. GENERAL INFORMATION ABOUT OPERATING
ELECTRICAL LOADS ON VOLTAGE INVERTERS
In principle, you can operate all 230V~ electrical loads whose power consumption is below the rated
maximum power output of inverters. However, in order to estimate the power requirement and the
corresponding reserves, it is important to know some properties of typical 230 V electrical loads.
Many 230 V electrical loads, such as refrigerators, have a much higher startup power consumption
than the rated permanent power consumption as it is indicated on the type plate. The startup power
28
consumption does not affect the mains operation in general, because corresponding power reserves
are available. However, the output of inverters is limited. Inverters can provide output only up to a
rated peak output level when accommodating the peak consumption during start up.
If the startup power consumption of an electrical load is higher than the peak load of a inverter, the
device to be connected is not suitable for the respective inverter.
Since the output voltage is not in sine wave, some connected electrical loads may become hotter than
its normal operating temperature.
8.

CARE

Wipe the housing of the inverter with a slightly damp cloth. Only use water to moisten the cloth. Do not
use chemicals or cleaning agents when cleaning.
9.

DISPOSAL

In order to preserve, protect and improve the quality of environment, protect human
health and utilise natural resources prudently and rationally, the user should return
unserviceable product to relevant facilities in accordance with statutory regulations.
The crossed-out wheeled bin indicates the product needs to be disposed separately and
not as municipal waste.
19