Shutting Down - Wilo PARA SCA Serie Einbau- Und Betriebsanleitung

LED display
7
8
9
Activating „back to
factory setting"

Shutting down

the pump
44
Control mode
Speed control range: medium
Speed control range: high
Speed control range: high
• Pressing the button for the 9th time returns to the basic
setting (speed control range: high, setting/curve II).
The factory setting is activated by pressing and holding
the operating button whilst switching off the pump.
• Press and hold the operating button for at
least 4 seconds.

All LEDs flash for 1 second.

The LEDs for the last setting flash for 1 second.
When the pump is switched on again, the pump runs
using the factory settings (delivery condition).
NOTICE
All settings/displays are retained if the power
supply is interrupted.
8 Decommissioning
Shut down the pump immediately if the connecting
cable or other electrical components are damaged.
• Disconnect the pump from the power supply.
• Contact Wilo customer service or a specialist technician.
Setting/curve
I
III
II
Wilo SE 08/2020