SPORTSTECH SX200 Benutzerhandbuch Seite 40

Target Calories
1. Use joggle wheel to set Target CALORIES
(preset value=100), press START/STOP workout in
Target Calories mode.
2. CALORIES begins to count down from Target value,
TIME/DISTANCE/RPM/SPEED & HEART RATE will display
value accordingly.
3. The character animation only show USER,
it will skip to next figure as per one fifth of the preset
Calories.
4. Press START/STOP button to stop workout,
STOP icon is blinking, all value will remain.
5. During workout, it is invalid to press
RESET /Joggle wheel /ENTER button.
6. In STOP mode, press RESET button,
monitor returns to function setting page.
Target HR
1. Use joggle wheel to set Target PULSE
(preset value=100), press START/STOP
to workout in Target HR. Mode.
Keep both hands hold on hand grips.
2. TIME begins to count up, DISTANCE/ CALORIES/ RPM/
SPEED & HEART RATE will display value accordingly.
3. The character animation only show USER,
it will skip to next figure as per 0.1KM (or ML).
4. If the measured heart rate reading is 50% above the
target heart rate, the arrow at the top right of the screen
points upwards and flashes to indicate that the user is
too fast. If the measured heart rate is 50% below the
target heart rate, this arrow flashes pointing downwards
to indicate that the user can speed up.
5. Press START/STOP button to stop workout,
STOP icon is blinking, all value will remain.
6. During workout, it is invalid to press
RESET /Joggle wheel /ENTER button.
7. In STOP mode, press RESET button,
monitor returns to function setting page.
40