Replacing The Platens - SISER TS-ONE Gebrauchsanweisung

TS
ONE

4.4 Replacing the Platens

4
The press can be equipped with platens and accessories as described in point 2.3.
By loosening screws A and C, both platens can be adjusted in relation to the axis of
the machine.
EN
To replace the platen proceed as follows:
1) Lower the upper platen until it rests on the lower one.
2) Disconnect the multiple plug/socket on the control panel.
3) Loosen the fastening screw A and raise the handle; the upper platen will slide off the
fastening pin while the lower platen remains in place. Remove the platen.
4) Loosen the fastening screw C and raise the lower platen, sliding it off the fastening pin.
5) Assemble the new platens starting with the bottom one and proceeding in reverse order as
described above.
42
TS-One Manual for use and maintenance
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
A
C
dowel
B