Switching On The Press - SISER TS-BASE Gebrauchsanweisung

ATTENTION:
Non-compliance with these instructions can cause:
1. Compromised control functions
2. Flickering display
3. Slow lowering of the heating plate
4. Faulty fuse
Keep these aspects in mind in the event of replacement.

3.2 Switching on the press

• Locate the lift handle and position the heat platen in the up (load) position.
• Locate the Power ON/OFF Switch on the press.
• Turn the Power Switch on.
This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Power ON/OFF Switch
TS-BASE Manual for use and maintenance
Mod. PRD 20/3 - Last updating 10/2019
TS
BASE
3
EN
25